|
Post by Jorge Reyes on May 19, 2005 7:28:56 GMT -8
|
|
|
Post by Gary Lecomte on May 24, 2005 5:22:30 GMT -8
In ALL My Projects, Capacitor values are in uF.
As to that Trigger coil: (I currently only have a couple of them, but until I can find a Supply, I'm not prepared to sell the ones I have.)
I am trying to get some so I can supply them to those wishing to make this project. **I found one supplier, but they only sell in Large Quantities, Over 1000 pieces. And that is Tooo Many.
Hopefully Later this week, I may have more.
|
|
|
Post by randomvisitor on Jul 8, 2005 13:02:56 GMT -8
|
|
|
Post by randomvisitor on Jul 8, 2005 13:04:54 GMT -8
Oops... looks like you might have to copy/paste the link.
|
|
|
Post by Gary Lecomte on Jul 9, 2005 4:34:35 GMT -8
All Capacitors in my Projects are in uF, unless Stated Otherwise.
That Transformer is Possing a Problem. I only have 2 of them and don't want to sell them. I have Found one supplier, but they only sell in Thousand Lots. and they won't even give out samples.
I "May" have another source with less of a minimum, But won't know till Monday at the Earliest. The guy I need to talk to is on holidays till than. If I can get them, I will buy about 25 or so and than be able to supply them to you. (AT MY COST, Plus Postage.)
|
|
|
Post by randomvisitor on Jul 12, 2005 14:32:29 GMT -8
|
|
|
Post by Gary Lecomte on Aug 1, 2005 10:24:13 GMT -8
Sorry for the Delay on my reply. I did Not see your post. No it is Not Suitable. It is NOT an Isolated Primary and Secondary. However I can Now Supply one of these Trigger Coils that does work. Take care.........Gary randomvisitor Guest Re: Electrostatic Air Filter « Reply #5 on Jul 12, 2005, 6:32pm » -------------------------------------------------------------------------------- Would the transformers I linked to above be of any use? The datasheet is here: www.mouser.com/catalog/specsheets/XC-600028.pdf
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 2, 2008 5:53:23 GMT -8
I have been wanting to build one of your filters for a number of years. I am going to give it a go. Does your circuit provide enough power for a 25x30 filter ? Thinking that since no real amount of current flows in the filter the answer is yes. I am having a bit of trouble finding the 10-100K 60KV resistor. Mouser has a power resistor www.mouser.com/catalog/specsheets/XC-600041.pdfThey say Dielectric withstanding Voltage: No evidence of flashover, mechanical damage, arcing or insulation break down I did not see where the say what voltage they tested at. From the schematic I see that a NE-2 can be used instead of this resistor. I would guess the resistor is better because the neon ages? Could you provide the caps and coils for 2 units ? I think I found everything else at Mouser and Newark. It would be nice to see a picture of a DIY filter.
|
|
|
Post by Gary Lecomte on Nov 2, 2008 6:49:24 GMT -8
1) The Resistor is NOT Needed at All and I Don't use one.
2) An LED just gives a Visual indication of power.
3) Yes it is capable of running a filter of almost any size, as long as your filter has no leakage. (It is Just a Static Voltage)
4) Want Parts? You Must Email Me. Make sure you put the word "Electronic" in the "Subject line". And I need to know Where you live, to determine the Shipping Cost. NOTE: It is Probably Cheaper to buy All the parts from me. As you will save on those additional Shipping charges from Mouser.
5) I didn't Make the Plates for my Electrostatic filter. I had the Electrostatic filter "Given to me", But the High Voltage circuit was Burnt Out. It was also a Poor design. That is why I designed and built this Electrostatic circuit.
I also Custom build Much Higher Trigger coils to use with this circuit, Not that you want higher voltages for the Electrostatic filter. But they are good for other applications.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 13, 2008 7:17:13 GMT -8
Gary! I found a good source of inexpensive trigger transformers if you are interested. Email and I will provide you with the link
|
|
|
Post by Gary Lecomte on Nov 13, 2008 7:51:27 GMT -8
Gary! I found a good source of inexpensive trigger transformers if you are interested. Email and I will provide you with the link Presently, I now have some of these trigger Coils But Might be good for Future Needs. Just email me the link to: chemelec@hotmail.com You MUST put the Word "Electronic" In the Subject Line.
|
|
|
Post by ChainMof on May 10, 2019 3:21:32 GMT -8
I like EDM bands! I really do! And my favourite electronic band is Chainsmokers! DJs Andrew Taggart and Alex Pall are about to perform more than 50 concerts for their fans in 2019 and 2020! To know more about Chainsmokers band in 2020 visit website <a href=https://chainsmokersconcerts.com>Chainsmokers tour Detroit</a>. You won't miss any performance in 2019 if you visit the link!
JUNK
|
|
|
Post by iyukysaa on Nov 3, 2019 18:14:39 GMT -8
crap
|
|
|
Post by volkswagenvan on Nov 3, 2019 21:37:00 GMT -8
SPAM Again!
|
|